USTER HVI 900 - Overview of System Calibration

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 5
Version 4.0 (1.99) Calibration - Page 5-2
3 Overview of System
Calibration
Calibration should be performed for each individual module of the HVI
(Length/Strength, Micronaire and Color/Trash). Start by selecting the
module item from the C
ALIBRATION MENU. Access the CALIBRATION MENU
by selecting the
Calibration item from the MAIN MENU.
Select each of the modules, highlight the name of the module to be
calibrated, and press ENTER. The procedures used for calibrating each
of the modules are explained in the following sections.
• Length/Strength Calibration — Refer to Section 2
• Micronaire Calibration — Refer to Section 3
• Color Calibration — Refer to Section 4
• Trash Calibration — Refer to Section 5
• Temperature Calibration — Refer to Section 6
•
Relative Humidity Calibration — Refer to Section 7
Calibrations are discussed in this manual in the suggested order for
performing an initial calibration.