USTER HVI 900 - Length;Strength Calibration

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 5
Version 4.0 (1.99) Calibration - Page 5-3
Note: Depending on the configuration of your instrument, the menu
displayed on your screen may differ from the figure shown in this
manual.
4 Length /Strength Calibration
The Length/Strength Calibration menu item is used to set the following:
•
Length Standard Calibration
• Calibration Mode
•
Length Units
•
Cotton Calibration
• ICC SL1%
• ICC SL2%
• Calibration Constants
• Calibration Cotton Standard Values
• Calibration Check Tolerances
• Length/Strength Setup
Each of these items is discussed in this section.