USTER HVI 900 - Page 138

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 7
Version 4.0 (1.99) Module Testing - Page 7-3
3.4.2 Identifier
The Identifier field is used to enter an identification number that defines
the lot or merchant number for a particular group of samples. This
identifying information should be entered when test results are to be
transmitted to a printer, the 940 DataManager, or an external
computer. Otherwise, you can proceed to Continue with Testing without
entering information in this field.
The Identifier number entered remains in effect until the next time the
Identifier field is changed in one of the modules. In Module Testing,
changing the Identifier field in one of the modules changes the identifier
number in all of the modules.
For example: The same identifier entered during Length/Strength
Testing will be displayed in the Micronaire and Color/Trash Module
Testing menus.
• When you have finished entering the Identifier information, press
ENTER to save the information and move to the next field.
3.4.3 Number of Tests
• This selection is used to indicate the number of Length/Strength tests
to be performed on each sample (maximum: 10 per sample).
•
Enter the desired number of tests and press ENTER.
This number will remain in effect in Length/Strength Module Testing until
it is changed. The number entered in Length/Strength Module Testing
does not affect the number entered in the Status Mode for System
Testing.