USTER HVI 900 - Page 236

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 10
Version 4.0 (1.99) Synthetic Fiber Testing - Page 10-24
5.4.1 Continue with Testing
This selection displays the screen (Synthetic Testing Screen) that is used
for testing Synthetic fibers.
5.4.2 Identifier
This is a required field if the test data is to be printed or transmitted.
You cannot proceed to
Continue with Testing without entering informa-
tion in the Identifier field.
When
Identifier is selected, a window will display where the identifying
number (up to 30 alphanumeric characters) of the fiber to be tested
should be entered. The identifier information is displayed to the right of
Identifier . This number remains in effect until the next time the Identifier
field is changed. Data is stored for the 940 DataManager or
transmitted to an external computer based on the identifier. Each
identifier is a separate file.
• When you have finished entering the identifier information, press
ENTER to leave the instruction statement.
5.4.3 Number of Tests
This selection displays an instruction statement below the menu
requesting the number of tests that are to be performed on each sample
(maximum of 10 per sample). Enter the desired number of tests and
press ENTER. This number will remain in effect for all Synthetic Fiber
Testing until it is changed.