USTER HVI 900 - Page 238

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 10
Version 4.0 (1.99) Synthetic Fiber Testing - Page 10-26
5.4.5 Strength Measurement
This selection alternates between No and Yes.
 No — Strength will not be measured during testing.
 Yes — Strength will be measured during testing.
5.4.6 Printer
This selection alternates between Off and On.
 Off — Test data will not be sent to the printer.
 On — Test data will be printed as the test is completed.
5.4.7 Print Mode
You can select the type of data printed from the test results. The
selections alternate between:
 Averages
 Individual Tests
 Extended Measurements
5.4.8 Graph Mode
You can select the type of graph to be printed from the test results. The
selections alternate between the following.
 None
 Fibrogram
 Stress/Strain
 Fibrogram & Stress/Strain