USTER HVI 900 - Page 243

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 10
Version 4.0 (1.99) Synthetic Fiber Testing - Page 10-31
When all the tests on a sample have been completed the average
(AVG) is displayed. The standard deviation is displayed if the number
of tests is five or greater. If you want to reject the last sample, even
though it was within tolerances according to the current Lot Limits
specification, press <! >. The last sample will be rejected and another
test requested. Otherwise, press ENTER to accept the data.
The screen is cleared of the test results and either "Enter ID" or "Enter
Fineness" is displayed on the instruction line for the next sample. Each
time a test series is completed, you must enter a new ID number (if
required) and fineness value (if requested) for the next sample.
5.6.1 To Exit Testing
The test cycle is continuous. When you are finished with testing, use the
following steps to exit.
• After a test series is complete, a blank Test Results Screen is
displayed requesting that you either "Enter ID" or supply the
micronaire value (if required). Press ENTER at "Enter ID" (if
required).
• If entering the fineness value via the keyboard, "Enter Fineness" is
displayed. Enter any value between 2 and 8. If the value is to be
determined via the micronaire test, "Weight from 8.5 to 11.5
grams of fiber. Mass" is displayed. Press ENTER. "Enter" is
displayed. Type any value between 2 and 8, then press ENTER.
Once a value has been entered the Operations options are
displayed.
— Press ESCAPE to exit
— Press <!> to reject (To reject the last test)
— Press <#> to set motors
• Press ESCAPE to exit.