PROCEDURE
1 Remove the round nuts (001, Figure 8-13) and the bolts (002) of the turning gear (003),
refer to section 4.3 Loosen a round nut with a pre-tensioner.
2 Clean the threads of the bolts (002).
3 Apply oil to the threads of the bolts (002).
4 Tighten the round nuts (001) related to the data given in Figure 8-13, refer to section 4.2
Tighten a round nut with a pre-tensioner.
Fig 8-13 Turning gear - do a check
CLOSE UP
• None
X62DF
AA00-3206-00AAA-360A-A
Maintenance Manual Turning gear - do a check of the screwed connections
Winterthur Gas & Diesel Ltd.
- 373 - Issue 002 2020-10
To Next Page
Loading...
