PROCEDURE
1 Prepare the servo oil pumps for removal.
1.1 Remove the applicable HP fuel pipes from the related fuel pumps.
1.2 Disconnect the electrical connections.
1.3 Remove all pipes from the servo oil pumps.
2 Remove the first servo oil pump.
2.1 Put the sling around the servo oil pump two times.
2.2 Attach the sling to the engine room crane.
2.3 Operate the engine room crane and put sufficient tension on the sling to hold the
weight of the servo oil pump.
2.4 Remove the nuts and the washers.
2.5 Remove the servo oil pump and the O-ring.
2.6 Move the servo oil pump to an applicable area.
2.7 Remove the sling from the servo oil pump.
3 Do Step 2 again to remove the other servo oil pump(s).
CLOSE UP
• None
X62DF
AA00-5551-00AAA-520A-A
Maintenance Manual Servo oil pump - remove
Winterthur Gas & Diesel Ltd.
- 534 - Issue 002 2020-10
To Next Page
Loading...
