WinGD X62DF - Page 9

13.3.5 HP fuel pipe (fuel pump to fuel rail) - prepare before removal..............752
13.3.6 HP fuel pipe (fuel pump to fuel rail) - remove............................754
13.3.7 HP fuel pipe (fuel pump to fuel rail) - grind the sealing face................756
13.3.8 HP fuel pipe (fuel pump to fuel rail) - install..............................760
13.4 HP pilot fuel pipe
13.4.1 HP pilot fuel pipe - remove............................................764
13.4.2 HP pilot fuel pipe - install............................................. 768
14 Group 9 - Monitoring instruments
14.1 Crank angle sensor unit
14.1.1 Crank angle sensor unit (supply unit) - remove the proximity sensor........774
14.1.2 Crank angle sensor unit (supply unit) - install the proximity sensor......... 778
14.1.3 Crank angle sensor unit (flywheel) - remove the proximity sensor..........782
14.1.4 Crank angle sensor unit (flywheel) - install the proximity sensor............786
14.2 Selective catalytic reduction system (SCR)
14.2.1 SCR - remove the valve..............................................790
14.2.2 SCR - install the valve................................................792
14.3 Electronic components
14.3.1 Gas detector - calibrate.............................................. 794
14.3.2 LDU-20 - remove....................................................800
14.3.3 LDU-20 - install..................................................... 804
14.3.4 CCM-20 - remove................................................... 808
14.3.5 CCM-20 - install.....................................................810
14.3.6 MCM-11 - remove................................................... 812
14.3.7 MCM-11 - install.....................................................814
14.3.8 IOM-10 - remove....................................................816
14.3.9 IOM-10 - install......................................................818
15 Tools
15.1 General for tools.........................................................822
15.2 Standard tools...........................................................824
15.3 Recommended tools..................................................... 870
16 Tightening instructions
16.1 Tightening instructions....................................................876
17 Maintenance overview
17.1 Maintenance overview....................................................878
X62DF
Maintenance Manual
Winterthur Gas & Diesel Ltd.
- 9 - Issue 002 2020-10