1128600 SmartPAC 2 with WPC 2000 Integration User Manual
3-14 Keyboard, Displays, Etc.
Selecting an Item on a Display
To select an item on a SmartPAC 2 display, highlight the item you want, using the cursor keys
(see page 3-6), and press ENTER. Figure 3-21 shows the Main Run Menu with the “CAM
SWITCH” item highlighted. SmartPAC 2 goes to the display you have selected, on which
you can select another item or make a setting. Screen messages tell you how to proceed on
each display.
Figure 3-20. SmartPAC 2 Display, Run Mode
Figure 3-21. Main Run Menu with “CAM SWITCH” Highlighted
PRESS #14
TOOL NUMBER 6160 PART CNTR 51635
FLANGE TWO HAND S.S.
PRESS ANGLE 270
CAMBIE
AL ESPANOL
USE THE CURSOR KEYS ENABLE SENSORS
TO MAKE SELECTIONS. COUNTERS
PRESS ENTER TO DIE PROTECTION
ACCESS SELECTION. CAM SWITCH
BRAKE MONITOR
TONNAGE/WAVEFORM
PRESS CONTROL
FEED CONTROL
TOOL INFORMATION
SHUTHGT/CNTRBAL
ERROR LOG
LOAD NEW TOOL
DIALOG MENU
TOGGLE HOT KEYS 1
270
F1
F2
F3
F4
F5
F6
F7
F8
Status box
Descriptive labels for
Function keys and Hot keys
Crank Angle/SPM
readout
Crank angle clock
Instructions
Menu
Run window
To Next Page
Loading...
Need help?
General