EasyManua.ls Logo

Wintriss SmartPAC 2 - WPC 2000 Operator Station; Figure 1-2. Operator Station Components (Side-Mounted Run;Inch Palm Buttons)

Wintriss SmartPAC 2
604 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1128600 SmartPAC 2 with WPC 2000 Integration User Manual
1-8 Introduction
WPC 2000 Operator Station
Figure 1-2 identifies the switches and indicator lamps on a Wintriss Operator Station. (The
configuration with side-mounted Run/Inch palm switches is shown.) Functions of Operator
Station components are provided following the figure.
Run/Inch Palm Switches (2)–Initiate press action when both switches are pressed at the
same time (Two-hand mode) or when only the left switch is pressed (One-hand mode).
Prior Act Lamp and Switch–An arming device that must be pressed in Continuous Two-
hand and Continuous Foot operating modes before a stroke can be initiated. When the switch
is pressed, the lamp illuminates for 8 seconds, indicating the interval within which the
operator must press the Run/Inch buttons or Foot Switch in order to stroke the press. Also
used in Automatic Single-stroke operation (see page 6-49).
Emergency Stop Switch–Stops the press immediately when you push it. The switch is not
spring-loaded, so you must pull it back to its original position to clear the emergency stop
(F13) fault (see page 7-8).
Top Stop Switch–Stops the press at the top of its stroke when pressed during Continuous
operation.
Palm Time Lamp–Illuminates when one Run/Inch palm button is depressed, turning off after
the 1/2-second palm time (“synchronous” time in ANSI terminology) on a standalone
Operator Station or the 5-second concurrent time on multiple Operator Stations. The other
palm button on a standalone Op. Station or all pairs of buttons on multiple Operator Stations
must be pressed before the lamp turns off in order to initiate a stroke.
Mute Lamp–Illuminates during muting of the light curtain on the upstroke. Requires
installation of a Shadow light curtain and optional light curtain muting firmware.
Figure 1-2. Operator Station Components (Side-mounted Run/Inch Palm Buttons)
PRIOR ACT
switch
PALM TIME
lamp
MUTE
lamp
TOP STOP
switch
EMERGENCY STOP
switch
RUN / INCH
palm switches
RUN/
INCH
RUN/
INCH
PALM
TIME
PRIOR
ACT
MUTE
TOP
STOP
WINTRISS
E
M
E
R
G
E
N
C
Y
S
T
O
P

Table of Contents

Other manuals for Wintriss SmartPAC 2