Xerox Phaser 4600

04/2016
2-36
Phaser 4600/4620/4622 Printer Service Manual
07-730-00, 07-731-00, 08-100-00
Revised
2 Status Indicator RAPS
Reassemble and perform SCP 6 Final Actions.
Replace these components in order until the error is corrected.
1. Feed Assembly, PL 7.25 Item 10
2. Pick Assembly, PL 8.25 Item 16
08-100-00 Jam 1 in Registration RAP
08-100-00 Media remains in the Registration Rollers.
BSD-Reference: WD 6
Initial Actions
• Check the media.
• Check Toner and Drum Cartridge installation.
• Check for obstructions blocking the media path.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the Registration Rollers for excessive wear, poor spring tension or contamination. The
rollers are undamaged and clean.
YN
Clean or replace the Registration Roller Assembly, REP 8.27.
Check for obstructions or debris in the media path. The media path is clear.
YN
Clear the media path of obstructions or debris.
Select dC330 code 08-850 to test the Registration Clutch. The clutch is engaged (on/off).
YN
Remove the Right Cover (REP 28.2) and reseat CN5 and P/J36, then retest. The clutch
is engaged.
YN
Replace the Registration Clutch, REP 4.3.
Reassemble and perform SCP 6 Final Actions.
Select dC330 code 08-820 to test the Feed Drive. The Feed Drive Assembly rotates (on/
off).
YN
Remove the Right Cover (REP 28.2) and reseat CN12 on the MCU Board, then retest.
The Feed Drive Assembly rotates.
YN
Replace the Feed Drive Assembly, REP 4.4.
Reassemble and perform SCP 6 Final Actions.
Replace these components in order until the error is corrected.
1. Registration Roller Assembly, PL 8.45 Item 12
2. Registration Clutch, PL 4.10 Item 7
A B