Service Manual 3-35
13,000.6x Errors - Program Faults
13,001.62: Thermals failed to read from printer NVRAM.
13,002.63: Value is not in valid range.
13,003.64: Thermal control task received an unexpected message.
13,004.65: Thermal control task was expecting initialization message, but received
other.
13,005.66: Thermal code tried to command a segment ID that did not exist.
13,006.67: Thermal code tried to command a segment ID that did not exist.
13,007.68: Thermal power manager task was expecting initialization message, but
received other.
13,008.60: Thermal power manager task received an unexpected message.
a. Reset NVRAM and retest.
b. Ensure ground integrity for the printer (see "Ensuring Ground Integrity" on
page 4-77).
Troubleshooting Procedure for 13,326 to 13,583 Error Code (Ink Loader)
Step Questions and Actions Yes No
1
1. Verify that the ambient temperature of the
room is within the printers optimal
environmental specification (see
"Environmental Specifications" on
page 1-11).
2. Is the room too cold or too hot?
Advise
customer of
specification
requirements.
Go to Step 2.
2
1. Ensure ground integrity of the printer (see
"Ensuring Ground Integrity" on page 4-77).
2. Are all components grounded properly?
Go to Step 3. Resolve ground
integrity.
3
1. Inspect and reseat the wiring to the ink
loader. Check for open wires.
2. Did this correct the problem?
Go to Step 4. Replace the I/O
board or the
combined right
cable.
4
1. Run the appropriate Ink Melt test.
1 = Yellow
2 = Cyan
3 = Magenta
4 = Black
2. Did the test pass?
Replace the ink
loader.
To Next Page
Loading...
Need help?
General