YASKAWA E-7S SERVOPACK SGD7S - Applicable Tools; Operating Procedure

6.10 Initializing the Vibration Detection Level
6.10.2 Applicable Tools
6-33
6
Application Functions
6.10.2 Applicable Tools
The following table lists the tools that you can use to initialize the vibration detection level and
the applicable tool functions.
6.10.3 Operating Procedure
Use the following procedure to initialize the vibration detection level.
1.
Click the Servo Drive Button in the workspace of the Main Window of the SigmaWin+.
2. Select Initialize Vibration Detection Level in the Menu Dialog Box.
The Initialize Vibration Detection Level Dialog Box will be displayed.
3. Select Pn311: Vibration Detection Sensitivity and Pn310: Vibration Detection Selec-
tions and then click the Detection Start Button.
A setting execution standby mode will be entered.
Tool Function Operating Procedure Reference
Digital Operator Fn01B
Σ-7-Series Digital Operator Operating Manual
(Manual No.: SIEP S800001 33)
SigmaWin+
Setup − Initialize Vibra-
tion Detection Level
6.10.3 Operating Procedure on page 6-33