YASKAWA E-7S SERVOPACK SGD7S - Automatic Detection of Connected Motor

5.3 Automatic Detection of Connected Motor
5-14
5.3 Automatic Detection of Connected Motor
You can use a SERVOPACK to operate either a Rotary Servomotor or a Linear Servomotor.
If you connect the Servomotor encoder to the CN2 connector on the SERVOPACK, the SER-
VOPACK will automatically determine which type of Servomotor is connected. Therefore, you
normally do not need to specify the Servomotor type.
If an encoder is not connected, e.g., for a test without a motor, you can specify a Rotary Ser-
vomotor or a Linear Servomotor in Pn000 = n.X (Rotary/Linear Startup Selection When
Encoder Is Not Connected). If you specify either a Rotary or Linear Servomotor, only the
parameters, monitors, alarms, and functions for the specified motor type will be enabled.
Information
Parameter Meaning When Enabled Classification
Pn000
n.0

(default setting)
When an encoder is not connected,
start as SERVOPACK for Rotary Servo-
motor.
After restart Setup
n.1

When an encoder is not connected,
start as SERVOPACK for Linear Servo-
motor.