6-1
Built-in Ethernet Communications
6
Built-in Ethernet Communications
This chapter explains how to communicate with devices (PLC, touch panel, etc.) connected to the
MP2300S by Ethernet.
6.1 Communication Methods - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -6-2
6.2 Communication with Other MP Series - - - - - - - - - - - - - - - - - - - - - - - - - -6-3
6.2.1 When the MP2300S Acts as Slave (automatic receive function is used) - - - - - - - - - - - 6-3
6.2.2 When the MP2300S Acts as Slave
(ladder program which uses a MSG-RCV function) - - - - - - - - - - - - - - - - - - - - - - - - 6-17
6.2.3 When the MP2300S Acts as Master (I/O message communication function is used) - 6-36
6.2.4 When the MP2300S Acts as Master
(ladder program which uses a MSG-SND function) - - - - - - - - - - - - - - - - - - - - - - - - 6-49
6.3 Communication with Touch Panel - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 6-65
6.3.1 When the MP2300S Acts as Slave (automatic receive function is used) - - - - - - - - - - 6-65
6.4 Communication with PLC Manufactured
by Mitsubishi Electric Corporation (MELSEC protocol) - - - - - - - - - - - - - 6-75
6.4.1 When the MP2300S Acts as Slave (automatic receive function is used) - - - - - - - - - - 6-75
6.4.2 When the MP2300S Acts as Master (I/O message communication function is used) - 6-83
To Next Page
Loading...
