YASKAWA MP2300S - Function Setting and Parameter Details for Non-Procedural Protocol

Appendix G MSG-SND/MSG-RCV Functions (Ethernet)
G.1 Message Transmit Function (MSG-SND)
A-77
Appendices
G.1.7 Function Setting and Parameter Details for Non-procedural Protocol
This section explains the MSG-SND function setting and its parameter list details when non-procedure is used as a pro-
tocol.
Note: Non-procedure communication protocol transmits the M register content intact without a protocol conver-
sion. You can create any protocol in accordance with the remote equipment.
( 1 ) Message Transmit Function Setting
( a ) 218IFA Setting Example
An example of a function setting when 218IFA is used as a communication device is as follows:
When non-procedure 2 (per byte) is used, set the Pro-Typ field to “00003” (non-procedure 1 (per word)).
Set the circuit number in accordance with the circuit number allocated to the target 218IFA.
Set a unique communication buffer channel number for the same circuit.
For information on the register number, refer to G.1.2 ( 1 ) Input Item and G.1.2 ( 2 ) Output Item .
( b ) 218IF Setting Example
An example of a function setting when 218IF is used as a communication device follows:
When non-procedure 2 (per byte) is used, set the Pro-Typ field to “00003” (non-procedure 1 (per word)).
Set the circuit number in accordance with the circuit number allocated to the target 218IF.
Set a unique communication buffer channel number for the same circuit.
For information on the register number, refer to G.1.2 ( 1 ) Input Item and G.1.2 ( 2 ) Output Item .
Execute
Communication device = 218IFA
Protocol =non-procedure 1
Circuit number = 1
Communication buffer channel number = 1
Parameter list start address = DA00000
(use DW00000 to DW00016)
Abort
Dev-Typ
Pro-Typ
Cir-No
Ch-No
Param
MSG-SND
Busy
Complete
Error
DB000201
DB000202
00016
00002
00001
DA00000
00001
DB000210
DB000211
DB000212
Execute
Abort
Dev-Typ
Pro-Typ
Cir-No
Ch-No
Param
MSG-SND
Busy
Complete
Error
DB000201
DB000202
00006
00002
00001
DA00000
00001
DB000210
DB000211
DB000212
Communication device = 218IF
Protocol =non-procedure 1
Circuit number = 1
Communication buffer channel number = 1
Parameter list start address = DA00000
(use DW00000 to DW00016)