YASKAWA MP2300S - Simple Setting Screen for Message Communication

2.2 Basic Module
2.2.4 218IFA Module (Ethernet)
2-22
 Simple Setting Screen for Message Communication
Graphically sets connection parameters for each connection.
Basically, the same content as with message communication items in connection parameter setting can be set.
When connection parameters are not yet set and this screen is opened, the default value for each connection will be
automatically stored.
The following table provides the default values for each connection stored when the connection parameters are not yet
set and this screen is opened.
By clicking the Default Button, default values are set for each data code type according to the selected communication
protocol type.
The following table shows the default values for each data code type.
Item
Default
Connection
Number 01
Connection
Number 02
Connection
Number 03
Connection
Number 04
Local Port No. 10001 10002 10003 10004
Node IP Address 192.168.1.2 192.168.1.3 192.168.1.4 192.168.1.5
Node Port Number 10001 10002 10003 10004
Communication
Protocol Type
Extended MEMOBUS
Connect Type TCP
Code BIN
Communication Protocol Type Default for Data Code Type
Extended MEMOBUS BIN
MEMOBUS RTU
MELSEC BIN
Non-procedure BIN
MODBUS/TCP BIN