YASKAWA MP2300S - When the MP2300 S Acts as Slave (Ladder Program Which Uses a MSG-RCV Function)

6.2 Communication with Other MP Series
6.2.2 When the MP2300S Acts as Slave (ladder program which uses a MSG-RCV function)
6-17
Built-in Ethernet Communications
6.2.2 When the MP2300S Acts as Slave (ladder program which uses a MSG-RCV
function)
The MP2300S can communicate with only one master when using the automatic receive function.
To communicate with more than one master, use a ladder program with a message receive function (MSG-RCV) at the
MP2300S end. You can use the message receive function (MSG-RCV) as well as the automatic receive function by
keeping connections separate from each other.
This section explains how to communicate with an MP2300 message transmit function (MSG-SND) using the
MP2300S message receive function (MSG-RCV).
Fig. 6.3 Message Flow with MP2300 when Message Receive Function (MSG-RCV) Is Used
MP2300S
MP
/
Ethernet
LINK
0
0
23
S
&%
&%
8
4.;
176
0V
;#5-#9#
6'56
4&;
#./
/6:
64:
470
'44
$#6
+2
59

59

10
10
%0()
+06
572
/10
5612
$#66'4;
M-I/II
'
'
6'56
+06
01
01
DC24V
DC 0V
MP2300
YASKAWA
TEST
RDY
ALM
TX
RUN
ERR
BAT
MON
CNFG
INT
SUP
STOP
SW1
OFF ON
BATTERY
CPU I/O
218IF-01
ERR
COL
RX
RUN
STRX
TX
INIT
TEST
ONOFF
PORT
10Base-T
Ethernet
Slave Master
Communication Protocol
Type
Connection Type
Data Code Type
Extended MEMOBUS
protocol
Ethernet
MP2300S
(Local station)
MP2300
218IFA
Extended MEMOBUS protocol
MSG-RCV function
(ladder application)
MSG-SND function
(ladder application)
Option Module
(218IF-01)
TCP / UDP
BIN / ASCII
(Remote station)
MP2300