6.2 Communication with Other MP Series
6.2.1 When the MP2300S Acts as Slave (automatic receive function is used)
6-10
e Set Subnet Mask (“255.255.255.000,” for example).
f Set Gateway IP Address (“000.000.000.000,” for example).
Caution
Set up a unique IP address in the network.
For the IP address, check with your network administrator.
3. Set connection parameters.
How to set up with a connection number 01 in the connection parameter setting screen
c Set Local Port to the port number used in the MP2300 side (“10001,” for example).
d Set Node IP Address to the IP address configured in the MP2300S side.
e Set Node Port to the port number configured in the MP2300S side (“10001,” for example).
f Select Connect Type (TCP, for example).
g Select Extended MEMOBUS for Protocol Type.
h Select Code (BIN, for example).
Caution
When any transmission or connection parameter is changed, the change will be reflected after FLASH has been saved and the
power turned ON again.
To Next Page
Loading...
Need help?
General
