6.3 Communication with Touch Panel
6.3.1 When the MP2300S Acts as Slave (automatic receive function is used)
6-72
8. Click the setup button of the connected PLC1 for each device setting to display the setting screen for
each device.
9. Set up the setting screen for each device.
In the setting screen for each device, set up a connected device (in this case, the MP2300S).
Set the IP address, port number and data code in the same manner as the 218IFA screen of the MP2300S.
• 218IFA screen (reference)
The setting is finished for now.
Create a screen and transfer the project to an indicator as required.
Caution
Set up a unique IP address in the network.
The MP2300S side IP address is set to “192.168.1.1” in self-configuration.
For the IP address, check with your network administrator.
Note: Set the GP3000 series IP address in the off-line mode of the indicator.
Contact Digital Electronics Corp. for more information.
Table 6.20 Each Device Setting
IP Address 192.168.001.001
Port Number 10001
Data Code binary
To Next Page
Loading...
