6.4 Communication with PLC Manufactured by Mitsubishi Electric Corporation (MELSEC protocol)
6.4.1 When the MP2300S Acts as Slave (automatic receive function is used)
6-80
7. Click Enable in the Automatically Reception Setting Window and then click the OK Button.
Note: For more information on Slave Side I/F Register Setting and Automatic Receive Process Delay Time,
refer to 2.2.4 ( 4 ) (b)
Automatic Receive Setting Screen for Message Communication .
The automatic receive function is now set up, when MP2300S acts as a slave.
Caution
When any transmission or connection parameter is changed, the change will be reflected after FLASH has been saved and the
power supply is turned ON again.
To Next Page
Loading...
