2.2 Basic Module
2.2.2 External Appearance, LED Indicators, and Switch Settings
2-10
[ b ] SW2
Sets the Ethernet port condition and other operating conditions.
The change of switch setting is invalid after the power is turned ON (read only when the module is initialized by soft-
ware).
No.
Switch
Name
State Operation Mode Default Description
S2-4 −
ON
Reserved
OFF
Reserved for future use
OFF
S2-3 −
ON
Reserved
OFF
Reserved for future use
OFF
S2-2 E-INIT
ON
Transmission parameter for
Ethernet, default
OFF
When ON, transmission parameters such as an IP
address are set to default at startup.
OFF Normal operation
S2-1 E-TEST
ON System use
OFF
Always leave set to OFF.
OFF Normal operation
To Next Page
Loading...
