130 CHAPTER 9: QOS COMMANDS
User Guidelines
There are no user guidelines.
Example
The following example displays the parameters of the aggregate policer
called ‘policer1’.
police aggregate The police aggregate Policy-map Class Configuration mode command
applies an aggregate policer to multiple classes within the same policy
map. To remove an existing aggregate policer from a policy map, use the
no form of this command.
Syntax
police aggregate aggregate-policer-name
no police aggregate aggregate-policer-name
Parameters
■
■ aggregate-policer-name — Specifies the name of the aggregate
policer.
·Default Configuration
This command has no default configuration.
Command Mode
Policy-map Class Configuration mode
User Guidelines
An aggregate policer can be applied to multiple classes in the same policy
map; An aggregate policer cannot be applied across multiple policy maps
or interfaces.
To return to the Policy-map Configuration mode, use the exit command.
To return to the Privileged EXEC mode, use the end command.
Console#
show qos aggregate-policer
policer1
aggregate-policer policer1 96000 4800 exceed-action drop
not used by any policy map
To Next Page
Loading...
