3Com 3CRUS2475 - Enable (Ap Radio); Channel

494 CHAPTER 35: WIRELESS AP RADIO COMMANDS
enable (ap radio) The enable AP Interface Radio Configuration mode command
administratively enables the radio. To administratively disable the radio,
use the no form of this command.
Syntax
enable
no enable
Parameters
This command has no keywords or arguments.
Default Configuration
Enable.
Command Mode
AP Interface Radio Configuration mode
User Guidelines
Use the wlan tx-power off Global Configuration command to globally
enable/disable TX power. TX power is enabled on specific AP only if TX
power is enabled globally and for the AP.
Example
The following example administratively enables the radio.
channel The channel AP Interface Radio Configuration mode command
configure the RF channel. To restore the default configuration, use the no
form of this command.
Console (Config-wlan-ap)# interface radio 802.11g
Console (Config-wlan-ap-radio)# enable