3Com 3CRUS2475 - Rts Threshold

498 CHAPTER 35: WIRELESS AP RADIO COMMANDS
Parameters
■ long — The AP supports long and short preambles.
■ short — The AP supports short preambles.
Command Mode
AP Interface Radio configuration mode
User Guidelines
This command is only relevant for 802.11g transceivers.
Example
The following example configures the preamble support for 802.11g
transceivers to long.
rts threshold The rts threshold AP Interface Radio Configuration mode command
configures the Request-To-Send (RTS) threshold. To restore defaults, use
the no form of this command.
Syntax
rts threshold number
no rts threshold
Parameters
■ number — Specifies the packet size, in bytes, above which the access
point negotiates an RTS/CTS before sending out the packet. (Range:
0-2347)
Default Configuration
The default RTS threshold is 2312 bytes.
Console (Config-wlan-ap)# interface radio 802.11g
Console (Config-wlan-ap-radio)# preamble long