3Com 3CRUS2475 - Show Bridge Address-Table

66 CHAPTER 4: ADDRESS TABLE COMMANDS
The command enables adding secure MAC addresses to a routed port in
port security mode. The command is available when the port is a routed
port and in port security mode. The address is deleted if the port exits the
security mode or is not a routed port.
Example
In this example, the MAC-layer address 66:66:66:66:66:66 is added to
port g1.
show bridge
address-table
The show bridge address-table Privileged EXEC mode command
displays all entries in the bridge-forwarding database.
Syntax
show bridge address-table [vlan vlan] [ethernet interface |
port-channel port-channel-number | address mac address]
Parameters
■ vlan — Specifies a valid VLAN, such as VLAN 1.
■ interface — A valid Ethernet port.
■ port-channel-number — A valid port-channel number.
■ mac address — A valid MAC address.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
Console(config)# interface ethernet g1
Console(config-if)#
port security routed secure-address
66:66:66:66:66:66