3Com 3CRUS2475 - Power

496 CHAPTER 35: WIRELESS AP RADIO COMMANDS
power The power AP Interface Radio Configuration mode command configures
the power level. To restore the default configuration, use the no form of
this command.
Syntax
power {max | half | quarter | eighth | min}
no power
Parameters
■ max — Maximum power.
■ half — Half of the maximum power.
■ quarter — Quarter of the maximum power.
■ eighth — Eighth of the maximum power.
■ min — Minimum power.
Default Configuration
Maximum power.
Command Mode
AP Interface Radio Configuration mode
User Guidelines
■ The maximum power depends on the country code that was set by
the wlan country-code Global Configuration command.
■ The power is off if the wlan tx-power off Global Configuration
command was activated.
Example
The following example configures the power level to half the maximum
power.
Console (Config-wlan-ap)# interface radio 802.11g
Console (Config-wlan-ap-radio)# power half