488 CHAPTER 34: 802.1X COMMANDS
Example
The following example forwards frames with source addresses that are
not the supplicant address and sends consecutive traps at intervals of 100
seconds.
dot1x guest-vlan The dot1x guest-vlan Interface Configuration (VLAN) mode command
defines a guest VLAN. To restore the default configuration, use the no
form of this command.
Syntax
dot1x guest-vlan
no dot1x guest-vlan
Default Configuration
No VLAN is defined as a guest VLAN.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Use the dot1x guest-vlan enable Interface Configuration mode
command to enable unauthorized users on an interface to access the
guest VLAN.
If the guest VLAN is defined and enabled, the port automatically joins the
guest VLAN when the port is unauthorized and leaves it when the port
becomes authorized. To be able to join or leave the guest VLAN, the port
should not be a static member of the guest VLAN.
Console(config)# interface ethernet g16
Console(config-if)#
dot1x single-host-violation forward trap
100
To Next Page
Loading...
