3Com 3CRUS2475 - Show Access-Lists

show access-lists 51
Parameters
■ acl-name—Specifies the ACL to be applied to the input interface.
Default Configuration
This command has no default configuration.
Command Mode
Interface (Ethernet, port-channel) Configuration mode.
User Guidelines
In advanced mode, when an ACL is bound to an interface, the port trust
mode is set to trust 12-13 and not to 12.
Example
The following example binds (services) an ACL to VLAN 2.
show access-lists The show access-lists Privileged EXEC mode command displays access
control lists (ACLs) defined on the device.
Syntax
show access-lists [name]
Parameters
■ name — The name of the ACL.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Console(config)# interface vlan 2
Console(config-if)#
service-acl input macl1