13
LACP COMMANDS
lacp system-priority The lacp system-priority Global Configuration mode command
configures the system priority. To restore the default configuration, use
the no form of this command.
Syntax
lacp system-priority value
no lacp system-priority
Parameters
■ value — Specifies system priority value. (Range: 1-65535)
Default Configuration
The default system priority is 1.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the system priority to 120.
lacp port-priority The lacp port-priority Interface Configuration (Ethernet) mode
command configures physical port priority. To return to the default
configuration, use the no form of this command.
Console(config)#
lacp system-priority
120
To Next Page
Loading...
