3Com 3CRUS2475 - Defining System Settings

port storm-control broadcast rate 97
port storm-control
broadcast rate
The port storm-control broadcast rate Interface Configuration
(Ethernet) mode command configures the maximum broadcast rate. To
restore the default configuration, use the no form of this command.
Syntax
port storm-control broadcast rate rate
no port storm-control broadcast rate
Parameters
■ rate — Maximum kilobits per second of broadcast and multicast traffic
on a port. (Range of 3500-1000000)
Default Configuration
The default storm control broadcast rate is 3500 Kbits/Sec.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast enable Interface Configuration
mode command to enable broadcast storm control.
Example
The following example configures a port storm-control broadcast rate
4000 on port g2.
show ports
storm-control
The show ports storm-control Privileged EXEC mode command
displays the storm control configuration.
Syntax
show ports storm-control [interface]
Parameters
■ interface — A valid Ethernet port. Elana
(config)# interface ethernet g2
Console(config-if)# port storm-control broadcast rate 4000