3Com 3CRUS2475 - Dot1 X Timeout Re-Authperiod

472 CHAPTER 34: 802.1X COMMANDS
Syntax
dot1x re-authentication
no dot1x re-authentication
Default Configuration
Periodic re-authentication is disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables periodic re-authentication of the client.
dot1x timeout
re-authperiod
The dot1x timeout re-authperiod Interface Configuration mode
command sets the number of seconds between re-authentication
attempts. To restore the default configuration, use the no form of this
command.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
Parameters
■ seconds — Number of seconds between re-authentication attempts.
(Range: 300-4294967295)
Default Configuration
Re-authentication period is 3600 seconds.
Command Mode
Interface Configuration (Ethernet) mode
Console(config)# interface ethernet g16
Console(config-if)#
dot1x re-authentication