3Com 3CRUS2475 - Interface Ethernet

356 CHAPTER 24: WIRELESS AP GENERAL COMMANDS
Syntax
wan enable
no wan enable
Parameters
This command has no keywords or arguments.
Default Configuration
Disabled
Command Mode
AP Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example accommodates certain timing constrains in the
communication to a remotely connected wireless AP separated by a WAN
link or the Internet.
interface ethernet The enter interface AP Configuration mode command configures an
interface and enters the Interface Configuration mode.
Syntax
interface ethernet
Parameters
This command has no keywords or arguments.
Default Configuration
This command has no default configuration.
Command Mode
AP Configuration mode
Console (Config)# wlan ap CR1 config
Console (Config-ap)#
wan enable