3Com 3CRUS2475 - Allow Traffic; Preamble

allow traffic 497
allow traffic The allow traffic AP Interface Radio Configuration mode command
allows users traffic. To disallow users traffic, use the no form of this
command.
Syntax
allow traffic
no allow traffic
Parameters
This command has no keywords or arguments.
Default Configuration
Users traffic is allowed.
Command Mode
AP Interface Radio Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example allows user traffic.
preamble The preamble AP Interface Radio Configuration mode command
configures the preamble support for 802.11g transceivers. To restore
default, use the no form of this command.
Syntax
preamble {long | short}
no preamble
Console (Config-wlan-ap)# interface radio 802.11g
Console (Config-wlan-ap-radio)# allow traffic