3Com 3CRUS2475 - C Troubleshooting; Problem Management; Troubleshooting Solutions

21
MANAGEMENT ACL COMMANDS
management
access-list
The management access-list Global Configuration mode command
configures a management access list and enters the Management
Access-list Configuration command mode. To delete an access list, use
the no form of this command.
Syntax
management access-list name
no management access-list name
Parameters
■ name — Access list name. (Range: 1-32 characters)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
Use this command to configure a management access list. The command
enters the Access-list Configuration mode, where permit and deny access
rules are defined using the permit (Management) and deny
(Management) commands.
If no match criteria are defined, the default is deny.
If you reenter an access list context, the new rules are entered at the end
of the access list.
Use the management access-class command to select the active access
list.
The active management list cannot be updated or removed.