3Com 3CRUS2475 - Defining Wireless Access Points

sntp anycast client enable 157
sntp anycast client
enable
The sntp anycast client enable Global Configuration mode command
enables SNTP anycast client. To disable the SNTP anycast client, use the
no form of this command.
Syntax
sntp anycast client enable
no sntp anycast client enable
Default Configuration
The SNTP anycast client is disabled.
Command Mode
Global Configuration mode
User Guidelines
Polling time is determined by the sntp client poll timer Global
Configuration mode command.
Use the sntp client enable (Interface) Interface Configuration mode
command to enable the SNTP client on a specific interface.
Example
The following example enables SNTP anycast clients.
sntp client enable
(Interface)
The sntp client enable Interface Configuration (Ethernet, port-channel,
VLAN) mode command enables the Simple Network Time Protocol (SNTP)
client on an interface. This applies to both receive broadcast and anycast
updates. To disable the SNTP client, use the no form of this command.
Syntax
sntp client enable
no sntp client enable
console(config)# sntp anycast client enable