3Com 3CRUS2475 - Configuring Address Tables

122 CHAPTER 9: QOS COMMANDS
Configuration and match Class-map Configuration commands to define
the match criteria of a class.
Only one policy map per interface per direction is supported. A policy
map can be applied to multiple interfaces and directions.
Example
The following example creates a policy map called ‘policy1’ and enters
the Policy-map Configuration mode.
class The class Policy-map Configuration mode command defines a traffic
classification and enters the Policy-map Class Configuration mode. To
remove a class map from the policy map, use the no form of this
command.
Syntax
class class-map-name [access-group acl-name]
no class class-map-name
Parameters
■ class-map-name — Specifies the name of an existing class map. If the
class map does not exist, a new class map will be created under the
specified name (Range: 0-32 characters).
■ acl-name — Specifies the name of an IP or MAC ACL.
Default Configuration
No policy map is defined.
Command Mode
Policy-map Configuration mode
User Guidelines
Before modifying a policy for an existing class or creating a policy for a
new class, use the policy-map Global Configuration mode command to
specify the name of the policy map to which the policy belongs and to
enter the Policy-map Configuration mode.
Console (config)# policy-map policy1
Console (config-pmap)#