3Com 3CRUS2475 - Viewing MAC-based ACLs

74 CHAPTER 4: ADDRESS TABLE COMMANDS
The following table describes the fields shown above.
show ports security
addresses
The show ports security addresses Privileged EXEC mode command
displays the current dynamic addresses in locked ports.
Syntax
show ports security addresses [ethernet interface | port-channel
port-channel-number]
Parameters
■ interface — A valid Ethernet port.
■ port-channel-number — A valid port-channel number
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
g2 Unlock
ed
Dynami
c
- 28 - -
g3 Locked Disabl
ed
Discar
d,
Shutdo
wn
8 Disabl
e
-
Field Description
Port The port number.
Status The values are: Locked/Unlocked.
Learning The learning mode.
Action Action on violation.
Maximum The maximum number of addresses that can be associated on
this port in theStatic Learning mode or in the Dynamic Learning mode.
Trap Sends traps in case of a violation.
Frequency The minimum time interval between consecutive traps.