3Com 3CRUS2475 - Mac Access-List

mac access-list 47
Default Configuration
This command has no default configuration
Command Mode
IP-Access List Configuration mode
User Guidelines
Use the ip access-list Global Configuration mode command to enable
the IP-Access List Configuration mode.
Before an Access Control Element (ACE) is added to an ACL, all packets
are permitted. After an ACE is added, an implied deny-any-any
condition exists at the end of the list and those packets that do not match
the defined conditions are denied.
Example
The following example shows how to define a permit statement for an IP
ACL.
mac access-list The mac access-list Global Configuration mode command enables the
MAC-Access List Configuration mode and creates Layer 2 ACLs. To delete
an ACL, use the no form of this command.
Syntax
mac access-list name
no mac access-list name
Parameters
■ name — Specifies the name of the ACL. (Range: 0-32 characters)
Default Configuration
The default for all ACLs is deny all.
Command Mode
Global Configuration mode
Console(config)# ip access-list ip-acl1
Console(config-ip-al)# deny rsvp 192.1.1.1 0.0.0.255 any