3Com 3CRUS2475 - Data-Rates

data-rates 417
Command Mode
BSS Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example advertises the BSS SSID.
data-rates The data-rates BSS Configuration mode command configures the data
rates used in a BSS. To restore defaults, use the no form of this
command.
Syntax
data-rates {[mandatory] add | remove} rate1 [rate1…12]
no data-rates
The command can be implemented as follows:
data-rates mandatory add rate1 [rate1…12]
data-rates {add | remove} rate1 [rate1…12]
Parameters
■ rate-list — Specifies the data rates that should be supported. Available
rates are as follows:
802.11g — 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48 and 54.
802.11a — 6, 9, 12, 18, 24, 36, 48 and 54.
Default Configuration
All rates are optional except for the following rates that are mandatory:
■ 802.11g: 1.
■ 802.11a: 6.
Command Mode
BSS Configuration mode
Console (Config-ap-radio-if)# bss configure enterprise
Console (Config-ap-bss-if)#