show policy-map 123
Use the service-policy (Ethernet, Port-channel) Interface Configuration
mode command to attach a policy map to an interface. Use an existing
class map to attach classification criteria to the specified policy map and
use the access-group parameter to modify the classification criteria of
the class map.
If this command is used to create a new class map, the name of an IP or
MAC ACL must also be specified.
Example The following example defines a traffic classification called
‘class1’ with an access-group called ‘enterprise’. The class is in a policy
map called policy1.
show policy-map The show policy-map Privileged EXEC mode command displays the
policy maps.
Syntax
show policy-map [policy-map-name [class-name]]
Parameters
■ policy-map-name — Specifies the name of the policy map to be
displayed.
■ class-name — Specifies the name of the class whose QoS policies are
to be displayed.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Console(config)#
policy-map
policy1
Console (config-pmap)#
class
class1
access-group
enterprise
To Next Page
Loading...
