3Com 3CRUS2475 - Defining VLAN Membership

144 CHAPTER 9: QOS COMMANDS
Syntax
qos map dscp-mutation in-dscp to out-dscp
no qos map dscp-mutation
Parameters
■ in-dscp — Specifies up to 8 DSCP values separated by spaces. (Range:
0-63)
■ out-dscp — Specifies up to 8 DSCP values separated by spaces.
(Range: 0-63)
Default Configuration
The default map is the Null map, which means that each incoming DSCP
value is mapped to the same DSCP value.
Command Mode
Global Configuration mode.
User Guidelines
This is the only map that is not globally configured. it is possible to have
several maps and assign each one to different ports.
Example
The following example changes DSCP values 1, 2, 4, 5 and 6 to DSCP
Mutation Map value 63.
security-suite
enable
The security-suite enable Global Configuration mode command
enables the security suite feature. Use the no form of this command to
disable the security suite feature.
Syntax
security-suite enable global-rules-only
no security-suite enable
Console(config)# qos map dscp-mutation 1 2 4 5 6 to 63