3Com 3CRUS2475 - Vlan Native; Wlan Template Ap Configure

358 CHAPTER 24: WIRELESS AP GENERAL COMMANDS
The following example adds VLANs 1,2,3 and 4 to the Ethernet port of a
wireless AP.
vlan native The vlan native AP interface Ethernet Configuration mode command
sets the native VLAN of the Ethernet port of a wireless AP. To restore the
default configuration, use the no form of this command.
Syntax
vlan native vlan-id
no vlan native
Parameters
■ vlan-id — VLAN ID of the native VLAN.
Default Configuration
VLAN #1
Command Mode
AP interface Ethernet Configuration mode
User Guidelines
A VLAN can be defined as a native VLAN only if it is one of the allowed
VLANs.
Example
The following example sets the native VLAN of the Ethernet port for a
wireless AP to 2.
wlan template ap
configure
The wlan template ap configure Global Configuration mode command
places the device in wireless AP Template Configuration mode.
Console (Config-ap)# interface ethernet
Console (Config-ap-if)#
vlan allowed add 1-4
Console (Config-ap)# interface ethernet
Console (Config-ap-if)#
vlan native 2