wpa2 pre-authentication 343
No key is defined.
Command Mode
Security-Suite ESS Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example defines that a group key should be updated after
a station leaves the AP.
wpa2
pre-authentication
The wpa2 pre-authentication ESS Configuration mode command
enables WPA2 pre-authentication in an ESS. Use the wpa2
pre-authentication command in ESS Configuration mode. To disable
WPA2 pre-authentication, use the no form of this command.
Syntax
wpa2 pre-authentication
no wpa2 pre-authentication
Parameters
This command has no keywords or arguments.
Default Configuration
This command has no default configuration.
Command Mode
ESS Configuration mode
User Guidelines
The command can only be enabled if WPA2 PMK caching is enabled.
Console (Config-wlan-ess)# security suite configure wpa
Console (Config-ess-security)#
update-gkey-on-leave
To Next Page
Loading...
