3Com 3CRUS2475 - Dot1 X Re-Authenticate; Dot1 X Timeout Quiet-Period

dot1x re-authenticate 473
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the number of seconds between
re-authentication attempts, to 300.
dot1x
re-authenticate
The dot1x re-authenticate Privileged EXEC mode command manually
initiates a re-authentication of all 802.1x-enabled ports or the specified
802.1x-enabled port.
Syntax
dot1x re-authenticate [ethernet interface]
Parameters
■ interface — Valid Ethernet port. (Full syntax: unit/port)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following command manually initiates a re-authentication of
802.1x-enabled Ethernet port g16.
dot1x timeout
quiet-period
The dot1x timeout quiet-period Interface Configuration mode
command sets the number of seconds that the device remains in the
Console(config)# interface ethernet g16
Console(config-if)#
dot1x timeout re-authperiod 300
Console# dot1x re-authenticate ethernet g16