3Com 3CRUS2475 - Viewing RMON Statistics

17
RADIUS COMMAND
radius-server host The radius-server host Global Configuration mode command specifies
a RADIUS server host. To delete the specified RADIUS host, use the no
form of this command.
Syntax
radius-server host {ip-address | hostname} [auth-port
auth-port-number] [timeout timeout] [retransmit retries] [deadtime
deadtime] [key key-string] [source source] [priority priority] [usage
type]
no radius-server host {ip-address | hostname}
Parameters
■ ip-address — IP address of the RADIUS server host.
■ hostname — Hostname of the RADIUS server host. (Range: 1-158
characters)
■ auth-port-number — Port number for authentication requests. The
host is not used for authentication if the port number is set to 0.
(Range: 0-65535)
■ timeout — Specifies the timeout value in seconds. (Range: 1-30)
■ retries — Specifies the retransmit value. (Range: 1-10)
■ deadtime — Length of time in minutes during which a RADIUS server
is skipped over by transaction requests. (Range: 0-2000)
■ key-string — Specifies the authentication and encryption key for all
RADIUS communications between the device and the RADIUS server.
This key must match the encryption used on the RADIUS daemon. To
specify an empty string, enter "". (Range: 0-128 characters)