3Com 3CRUS2475 - Update-Gkey-On-Leave (Security-Suite ESS)

342 CHAPTER 23: WIRELESS ESS COMMANDS
■ reauth-time seconds — Re-authentication timeout period. (Range:
1-4294967295)
■ idle-time seconds — DLE timeout period. (Range: 1-9676800)
■ never — There is an unlimited rekeying timeout period.
Default Configuration
■ rekey-time-unicast — Never
■ rekey-time-multicast — Never
■ reauth-time — 14400
■ idle-time — Never
Command Mode
Security-Suite ESS Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the key exchange timers for a
security-suite as an unlimited rekeying timeout period.
update-gkey-on-lea
ve (Security-Suite
ESS)
The update-gkey-on-leave Security-Suite ESS Configuration mode
command defines that a group key should be updated after a station
leaves the AP. To disable updates, use the no form of this command.
Syntax
update-gkey-on-leave
no update-gkey-on-leave
Parameters
This command has no keywords or arguments.
Default Configuration
Console (Conf\ig-wlan-ess)# security suite configure wpa
Console (Config-ess-security)#
timer rekey-time-unicast never