68 CHAPTER 4: ADDRESS TABLE COMMANDS
Parameters \
■ vlan — Specifies a valid VLAN, such as VLAN 1.
■ interface — A valid Ethernet port.
■ port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
In this example, all static entries in the bridge-forwarding database are
displayed.
show bridge
address-table count
The show bridge address-table count Privileged EXEC mode command
displays the number of addresses present in the Forwarding Database.
Console#
show bridge address-table static
Aging time is 300 sec
vlan mac address port type
---- --------------
---
---- --------------
---
1 00:60:70:4C:73
:FF
g8 Permanent
1 00:60.70.8C.73
:FF
g8 delete-on-time
out
200 00:10:0D:48:37
:FF
g9 delete-on-rese
t
To Next Page
Loading...
