3Com 3CRUS2475 - Switchport Trunk Allowed Vlan

switchport trunk allowed vlan 459
Parameters
■ vlan-id — Specifies the ID of the VLAN to which the port is configured.
Default Configuration
All ports belong to VLAN 1.
Command Mode
Interface configuration (Ethernet, port-channel) mode
User Guidelines
The command automatically removes the port from the previous VLAN
and adds it to the new VLAN.
Example
The following example configures a VLAN ID of 23 to the untagged layer
2 VLAN Ethernet port 1.
switchport trunk
allowed vlan
The switchport trunk allowed vlan Interface Configuration mode
command adds or removes VLANs to or from a trunk port.
Syntax
switchport trunk allowed vlan {add vlan-list | remove vlan-list}
Parameters
■ add vlan-list — List of VLAN IDs to be added. Separate
nonconsecutive VLAN IDs with a comma and no spaces. A hyphen
designates a range of IDs.
■ remove vlan-list — List of VLAN IDs to be removed. Separate
nonconsecutive VLAN IDs with a comma and no spaces. A hyphen
designates a range of IDs.
Default Configuration
This command has no default configuration.
Console(config)# interface ethernet 1
Console(config-if)# switchport mode
access